Skip to content

US Based Company

Ships From USA Warehouses

100,000+ Lights Shipped

Trusted by Contractors Nationwide

Contractor Pricing

Bulk Discounts Available

Orders Before 2PM

Ship Same Day

Expert Support

Lighting Specialists

Parking Garage Lighting Guide

Parking garage lighting guide

Parking garages are lit 24 hours a day, every day, which makes them one of the biggest lighting energy users in a building and one of the best places to switch to LED. Good garage lighting also matters for safety: drivers need to see pedestrians and columns, and people walking to their cars need to feel secure. This guide covers light levels, fixture types, layout, and controls.

Commercial parking garage aisle with overhead lighting

Light levels

Garage lighting is commonly designed to about 1–5 foot-candles in parking areas and drive aisles, with more at entrances, ramps, and stairs. Entrances are a special case: during the day, drivers coming in from bright sunlight need a brighter transition zone so their eyes can adjust. Uniformity matters as much as the average, since dark spots between fixtures make people feel unsafe and hide hazards.

See how many lumens do I need?.

Fixture types

  • Vapor tight linear fixtures: sealed 4 ft and 8 ft fixtures handle moisture, exhaust, and road salt. Browse vapor tight lights.
  • Garage canopy fixtures: low-profile square or round fixtures that surface mount to the ceiling, with wide light spread. See LED garage fixtures.
  • Wall packs at entrances and on exterior walls; see the wall pack buying guide.
  • Stairwell fixtures with sensors and emergency backup; see stairwell lighting.

Look for wet or damp location ratings, an IP rating suited to wash-down if the garage is hosed out, and impact resistance where fixtures are low. See IP ratings and wet locations and IK impact ratings.

Layout

  • Center fixtures over drive aisles and parking stalls so light falls on both cars and walkways.
  • Space fixtures to avoid dark zones between columns and beams; low garage ceilings, often 7–10 ft, call for wide-spread fixtures at closer spacing.
  • Add light at pedestrian crossings, elevators, stair doors, and pay stations.
  • Light the top deck like a parking lot, with poles and area lights.

Parking garage with emergency lighting

Controls save the most

Many garages are nearly empty for much of the night. Occupancy sensors that drop fixtures to a low level, such as 10–30%, when no one is around, and bring them to full when a car or person enters, can cut energy dramatically while keeping the garage from going dark. Many energy codes now require this kind of control in parking garages. Daylight sensors can dim fixtures near open sides of the garage during the day. See 0–10V dimming and lighting controls.

Emergency lighting

Garages need emergency lighting along pedestrian paths to exits and stairs. Emergency drivers in garage fixtures or separate emergency units can cover this. See emergency lighting and exit sign basics.

Converting from HID and fluorescent

Older garages often use 150W or 175W metal halide or HPS fixtures, or fluorescent strips:

  • 150–175W metal halide or HPS (about 190–210W system): 40–60W LED
  • 250W metal halide (about 290W system): 60–100W LED
  • 2-lamp T8 fluorescent strip: 20–40W LED vapor tight or strip

Because garages run 8,760 hours a year, savings add up fast. Fifty 175W metal halide fixtures (about 210W system) replaced with 50W LED save about 50 × 160W × 8,760 ÷ 1,000 = 70,000 kWh a year, roughly $9,100 at $0.13 per kWh, before adding occupancy sensors. See LED savings and payback.

Example: one garage level

  • Size: about 200 x 120 ft, or 24,000 sq ft, with a 9 ft ceiling.
  • Target: about 3 foot-candles average.
  • Total lumens: 24,000 × 3 ÷ 0.5 ≈ 144,000 lumens (0.5 for beams, columns, and dark concrete).
  • With about 5,000-lumen vapor tight or garage fixtures: about 29 fixtures, in rows over the drive aisles and parking rows, adjusted to work around beams.

Security and cameras

  • Light faces, not just the floor: fixtures with wide spread put light on vertical surfaces.
  • Light elevator lobbies, stair doors, and pay stations brightly.
  • Avoid deep shadows behind columns.
  • Use 4000K–5000K for clearer camera footage.

Painting and reflectance

White-painted ceilings and columns reflect light and can improve brightness and uniformity noticeably, letting you use fewer fixtures or lower wattage. Dark, unpainted concrete absorbs a lot of light.

Maintenance

Garages are dusty and damp. Sealed fixtures keep dirt out of the optics. Wash lenses during regular cleaning and inspect gaskets.

Common mistakes

  • Fixtures hidden behind beams, leaving dark stalls.
  • No transition lighting at entrances.
  • No sensors on a garage that runs 24/7.
  • Non-sealed fixtures in damp, salty environments.

Frequently asked questions

How bright should a parking garage be?

Commonly 1–5 foot-candles in parking areas, brighter at entrances, ramps, and stairs.

What lights are best for parking garages?

Wet-location vapor tight linear fixtures or low-profile garage fixtures, with occupancy sensors.

What color temperature for a parking garage?

4000K or 5000K are common; 5000K gives a bright, clean look and clear camera footage.

Related

LED garage fixtures · Vapor tight lights · Stairwell lighting · Security lights · Request a layout · Lighting resources

Compare products

{"one"=>"Select 2 or 3 items to compare", "other"=>"{{ count }} of 3 items selected"}

Select first item to compare

Select second item to compare

Select third item to compare

Compare