LED lifespan, L70 ratings, and warranties
LED fixtures are often advertised with lifespans of 50,000, 100,000, or more hours. Those numbers mean something specific, and they are not the same as how long the warranty lasts or how long the driver will run. This guide explains how LED life is measured, what affects it, and what to look for in a warranty.

LEDs fade instead of burning out
Incandescent and HID lamps usually fail suddenly. LEDs rarely do. Instead, their light output slowly declines over many years. So LED life is measured as the time until output drops to a set percentage of the original.
L70, L80, and L90
- L70: hours until output falls to 70% of initial lumens. The most common rating.
- L80 and L90: hours until output falls to 80% or 90%. Stricter measures.
A fixture rated "L70 at 100,000 hours" is expected to still produce 70% of its original light after 100,000 hours. A 30% drop is about the point where most people start to notice the space is dimmer.
How long is 50,000 or 100,000 hours?
- Office, 3,000 hours a year: 50,000 hours is about 16 years; 100,000 hours about 33 years.
- Two-shift warehouse, 5,000 hours a year: 50,000 hours is 10 years; 100,000 hours 20 years.
- Dusk-to-dawn outdoor, 4,300 hours a year: 50,000 hours is about 11.5 years; 100,000 hours about 23 years.
- 24/7 operation, 8,760 hours a year: 50,000 hours is about 5.7 years; 100,000 hours about 11.4 years.
How LED life is tested
LED manufacturers test LED packages under a standard called LM-80, measuring output over thousands of hours. A second method, TM-21, projects those results forward to estimate L70 life. TM-21 limits how far projections can go, which is why you may see ratings like "L70 > 54,000 hours" instead of a larger number.
What shortens LED life
- Heat. Heat is the main enemy of LEDs and drivers. Good fixtures use heat sinks to pull heat away. Do not install fixtures in spaces hotter than their rated ambient temperature, or bury them in insulation unless they are rated for it.
- Power quality. Voltage spikes and surges can damage drivers. Outdoor fixtures often include surge protection.
- Moisture. Use wet-location or IP-rated fixtures where needed; see IP ratings and wet locations.
- Driving harder. Running LEDs at higher current shortens life. Selectable fixtures run cooler on lower settings.
The driver matters too
The LED driver converts line power to the DC current LEDs need. Drivers have electronic components that age, especially in heat. In practice, a driver may fail before the LEDs reach L70. That is why a warranty that covers the complete fixture, including the driver, matters.
What to look for in a warranty
- Length: commercial fixtures commonly carry 5-year warranties; some carry 10.
- Coverage: the complete fixture, including LEDs, driver, and housing, not just the LEDs.
- Conditions: proper installation, within rated voltage and temperature.
- Process: how to file a claim and what proof is needed.
Steel Tech Lights fixtures are covered by our 5-year limited warranty against defects in materials and workmanship. Orders also include 60-day returns.
Getting the most life from your fixtures
- Choose fixtures rated for the environment: temperature, moisture, and dust.
- Use surge protection outdoors and on long circuits.
- Keep heat sinks clean and clear.
- Use selectable wattage or dimming to avoid running at full output when you do not need it; see selectable wattage and CCT.
- Add occupancy sensors to reduce operating hours; see photocells and motion sensors.
Comparing life across lighting types
Typical rated life before replacement:
- Incandescent: about 1,000 hours
- Halogen: about 2,000–4,000 hours
- Fluorescent T8: about 20,000–36,000 hours
- Metal halide: about 10,000–20,000 hours, with major output loss before failure
- High-pressure sodium: about 24,000 hours
- LED fixtures: commonly 50,000–100,000+ hours to L70
What this means for maintenance
In a warehouse running two shifts with 400W metal halide, lamps might be replaced every two to four years, often with a lift rental each time. LED high bays rated for 100,000 hours can run 20 years at 5,000 hours a year before reaching L70. Even if drivers need occasional replacement, maintenance drops dramatically.
B10 and B50 ratings
Some manufacturers also publish failure-based ratings, such as B50 (when 50% of a population is expected to have failed) or B10 (when 10% have). These are more common in technical specs than on product pages.
Planning for end of life
- Keep spare fixtures from the same batch for future replacements.
- Note model numbers and settings on your drawings.
- Recycle old fixtures responsibly.
- Expect to upgrade before the LEDs wear out, as efficiency keeps improving.

Common mistakes
- Assuming 100,000 hours means the warranty runs that long. Warranty terms are separate.
- Installing in heat beyond the rating. It is the most common cause of early failure.
- Ignoring surge protection on outdoor and industrial circuits.
Frequently asked questions
How long do LED lights last?
Commercial LED fixtures are commonly rated for 50,000–100,000+ hours to L70, which is 10–30 years in many applications.
What does L70 mean?
The number of hours until the LED's light output drops to 70% of its original output.
Does turning LEDs on and off shorten their life?
No. Unlike fluorescent and HID, frequent switching does not significantly shorten LED life, which is why LEDs work well with sensors.
Related
Warranty · Certifications and compliance · Lumens, watts, and efficacy · Lighting glossary · Lighting resources