Gas station and canopy lighting guide
A well-lit fuel canopy draws customers in from the road, makes them feel safe at night, and lets cameras capture clear footage. Canopy lighting also runs every night of the year, which makes it one of the best places to save with LED. This guide covers light levels, fixture selection, layout, and conversion from metal halide.

Light levels under a canopy
Fuel canopies are commonly lit to about 20–50 foot-candles at the pump islands, brighter than the surrounding lot. Brighter canopies attract attention, but too much light creates glare and makes the surrounding lot look darker by comparison. Many towns limit canopy brightness, so check local rules.
Keep the transition between the canopy, the lot, and the store entrance gradual. See how many lumens do I need? and our gas station and convenience store layout guide.
Choosing canopy lights
- Output: canopy fixtures commonly range from about 50W to 150W LED. Our gas station canopy light is selectable from 100W to 150W, up to about 21,000 lumens.
- Mounting: surface mount to the canopy deck or recessed into the deck. Low-profile fixtures keep the canopy clean. Recessed and flat-lens fixtures help limit glare and light trespass.
- Ratings: canopy fixtures should be rated for wet or damp locations, depending on exposure.
- Color temperature: 5000K is common for a bright, clean look; 4000K is a softer alternative.
- Hazardous areas: the areas immediately around fuel dispensers can be classified hazardous locations. Fixtures on the canopy deck are usually outside those areas, but follow your engineer's and inspector's requirements. See hazardous location lighting.
Browse LED canopy lights and gas station lighting.
Layout
- Place fixtures in a grid across the canopy, typically 10–15 ft apart at 15–18 ft mounting height.
- Line fixtures up over the pump islands and the drive lanes between them.
- Keep fixtures back from the canopy edge to limit glare toward the road.
- Light the canopy edges and approaches with the parking lot lighting so drivers' eyes can adjust.

Converting from metal halide
Older canopies typically use 250W or 400W metal halide fixtures:
- 250W metal halide (about 290W system): about 75–100W LED
- 400W metal halide (about 458W system): about 120–150W LED
Canopy lights often run 4,300 or more hours a year, many stations 24/7. At 24/7 operation and $0.13 per kWh, replacing twelve 400W metal halide canopy fixtures with 150W LED saves about 12 × 308W × 8,760 ÷ 1,000 = 32,400 kWh, roughly $4,200 a year. See LED savings and payback.
Beyond the canopy
- Store front and entrance: wall packs or soffit lights.
- Parking lot: shoebox area lights on poles; see outdoor distribution types.
- Signs: flood lights aimed down at the sign face.
- Car wash bays: vapor tight fixtures.
- Drive-thru lanes: canopy lights over the lane and menu board.

Example layout: 8-pump canopy
A typical 8-dispenser canopy might be about 100 ft long and 60 ft wide, roughly 6,000 sq ft.
- Target: about 30 foot-candles at the pump islands.
- Total lumens: 6,000 × 30 ÷ 0.65 ≈ 277,000 lumens.
- With about 20,000-lumen canopy lights: about 14 fixtures, often arranged in two or three rows over the islands and lanes.
Selectable wattage lets you start at full output and turn fixtures down if the canopy is brighter than local rules allow. See selectable wattage and CCT.
Lighting that helps sales
- Bright, even canopies read as open and safe from the road.
- Lit store entrances and windows draw people inside.
- Clear sign lighting helps drivers find the station and read prices.
- Consistent color temperature across canopy, lot, and store makes the site look cared for.
Our gas station and convenience store layout guide covers this in more detail.
Safety and security
- Light every pump island, the store entrance, and the path between them.
- Avoid dark zones at the edge of the canopy and around air and vacuum stations.
- Use 4000K–5000K for clear security camera footage.
- Keep lights on dusk-to-dawn with photocells, or 24/7 where stations never close.
Maintenance
Canopy fixtures collect dust and insects. Clean lenses during regular canopy cleaning to keep output up. LED fixtures need no relamping, which removes the most common reason for lift rentals at stations.
Common mistakes
- Over-lighting the canopy so the surrounding lot looks dark.
- Fixtures at the canopy edge that glare at drivers on the road.
- Mixing old metal halide and new LED under one canopy; the color difference is obvious.
- Ignoring local brightness limits on canopies.
Frequently asked questions
How bright should a gas station canopy be?
Commonly about 20–50 foot-candles at the pump islands, subject to local rules.
What wattage LED replaces a 400W metal halide canopy light?
Typically 120–150W LED.
Are canopy lights waterproof?
They should be wet- or damp-location rated for canopy use. Check the product page.
Related
LED canopy lights · Gas station lighting · LED gas station lights · Parking lot lights · Request a layout · Lighting resources